Soldering should be avoided as it is very easy to get solder into the spring connector part. The crimps can be attached, with care, using a standard 0.1" servo connector crimp tool or a pair of serated jaw needle nose pliers can be used. However, eight years ago, when I first started using the 2-pin JST, I had a fly-away, because the pin connection was not reliable. The 3 pin plugs are increasingly used on small 2S LiPo batteries for dual use as power and balance connector. Current is about 10 amps connector is the red 2-pin JST. The 2 pin plugs are the same as used on 1S batteries for E-flite UMX models - e.g. The other ends of the wires are unterminated they can be cut to length to match your application. Both packs contain 5 spare crimps for you to practice attaching them to wires. TAKE CARE: the convention for wiring these connectors has the positive and negative wires on opposite sides when comparing the 2 pin and 3 pin - see connector wiring for details.Ī 5 pack of 2 and 3 pin JST-PH plug shells and crimps. The 3 pin is used on 2S LiPo to eliminate the need for separate discharge and charge/balance connectors. The 2 pin connector is used on 1S LiPo where the discharge current would exceed the safe limit for a 'UM' connector. the E-flite Blade mCPX helicopter, the Spektrum AR6400LBL receiver and several Parkzone, E-Flite 'UMX' models. The JST-PH connector is used on many high current micro ESC and LiPo batteries - e.g. JST-SH | Molex Picoblade (1.25mm) | JST-ZH | Molex 2mm | JST-RCY | 1.27mm | AR6400/PKZ3352 | DC | Power The wires are red and black and 130 mm long. About shipping charges and VAT if your delivery address is outside the U.K. The Jumper Wire (JST Connector) is very useful for connecting electromechanical devices solder the free ends to devices such as motors, sensors and other devices, and use the JST connector to be able to plug/unplug them from breadboards or PCBs.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |